1. To clean, use a non-abrasive
mild soap. Never use abrasive cleaners
such as Comet. Some suggestions are windex, ivory liquid or mr. clean
gel for bathrooms. As long as it does not have the 'corrosive hand'
symbol on the bottle, it is usually safe to use.
2. Use Gel Gloss TM weekly to maintain a high-gloss finish and prolong
the life of your product.
3. Dull areas or light scratches may be removed by using an automotive
rubbing compound or scratch remover followed by an application of Gel
Gloss TM.
4. To remove chips and gouges we suggest that you contact a qualified
service repair person. Accidental damage, negligence, alteration, abuse
or misuse is not covered by the warranty.
5. Cultured marble, granite and onyx will not stain under normal use
with products usually found in the bathroom. Products such as iodine,
nail polish, nail polish remover, hair dye, shoe polish, after-shave
and cologne should be removed immediately.
6. Excessive heat or drastic alterations in water temperature can lead
to premature wear in cultured marble, granite and onyx. In order to
ensure longevity of the product, ensure that hot water temperatures are
within new home standards and do not exceed 1400F. Avoid drastic
changes in water temperature by mixing hot and cold water.
7. Bath tubs: General cleaning is the same as above. However, there is
a little extra care and maintenance that goes into caring for your
relaxing investment.
We recommend that the jet system
be cleaned as
follows after every ten uses:
Fill tub with warm water to cover the
highest jet. Close air controls. Add two teaspoonfuls of dishwasher
detergent and four ounces of bleach to the tub and run the system for
fifteen minutes. Drain tub. Refill with warm water and run the system
for another fifteen minutes to flush out remaining cleaning products.
Dry with a soft cloth. If the jet system is not maintained, dirt and
soap residue may form stains beneath the jets.
FITTINGS: Plastic
fittings require no extra care. Metal fittings may be
cleaned with a soft cloth and mild liquid detergent; abrasive cleaners
should not be used as they may scratch the surface. The jet cover may
be manually removed and cleaned with a damp cloth and replaced. |
|
